iBiz USB Charger Cable for Compaq and HP iPaq PDAs - NEW

This cable extends up to 60" and has a USB connection on one end and the round, yellow tipped, power connector that is the same as found on most iPaq PDA A/C adapters.

You can use this cable instead of the HP A/C adapter to charge your PDA using power from a USB port. So if you are travelling or just out in meetings all day you don't have to carry an extra wall charger with you! For iPaq models that have the round power connector built in at the bottom of the handheld unit you just plug this cable directly into the iPaq. For newer models, starting with the 3800 series, you woud plug this cable into the travel connector. The easiest way to think about it is that is just connects like your A/C adapter would.

Note that since USB ports don't provide as much power as the A/C adapter it may not charge your unit as fast as the A/C adapter but some tests we did here showed that it did a pretty good job.

IMPORTANT NOTE: This cable plugs in where the ADP-10SB power adapter would normally plug into. So if your iPaq needs a connection adapter or cradle to charge you will still need them to use this cable. For iPaqs that have the seperate round power port then this will plug directly in like you would normally plug the ADP-10SB adapter.

Compatible Models (that we know of so far):

iPaq 3600 series

3630

3635

iPaq 3700 series

3765

iPaq 3800 series and later when used with a travel connector such as 253652-B21.

iPaq 5400 series

iPaq 5500 series

(Probably any model that uses the ADP-10SB A/C adapter)